Safety & Warnings
- Connect the load lines and power lines and ensure that all the connections are correct before turning on.
- Ensure that there is no obstacle between the IR controller and the receiver when operating.
- This product should not be used at outdoor and any other humid environment. Do not allow it to contact water or any other liquid. Do not allow it to be dropped or suffer an impact. Do not use it in a high-temperature or high-pressure environment.
- Kogan.com will not be responsible for any product damage, property damage, personal injury or other losses which are caused by improper use.
Overview
Button |
Function |
![]() |
Adjust the brightness (16 levels) In colour change mode: Set the light flashing rate (8 levels) |
ON/OFF |
Turn controller on/off |
Colour |
Select corresponding static colour |
JUMP3 |
Colour change mode (3 colours) |
JUMP7 |
Colour change mode (7 colours) |
FADE3 |
Colour change mode – fading in/out (3 colours) |
FADE7 |
Colour change mode – fading in/out (7 colours) |
|
Sound-Control Mode 1 (General): |
![]() |
Sound-Control Mode 2 (Slow): |
![]() |
Sound-Control Mode 3 (Active): |
![]() |
Sound-Control Mode 4 (DJ): |
Setup
Setup Diagram
Installation Diagram
1. Connect the controller to the car’s power supply, press the switch button and test the light using the remote control.
2. Remove the protective film from the double-sided adhesive.
3. Install the lights with shorter leads under the front and back of the driver's seat, and install the lights with the longer leads under the front and back of the front passenger seat.
4. Run the lead under the footrest or through an appropriate crevice to completed the installation.
Specifications
Working Temperature |
-20°C ~ 60°C |
Input Voltage |
DC 12V / 2A |
Connecting Mode |
Common Anode |
Static Power Loss |
<1 W |
Output Power |
<9.6W |