Bella Vita Air Pressure Pneumatic Leg & Foot Massager - (BVAIRPLEGMA) - Manual – Kogan.com Help Centre

Safety & Warnings

Read all instructions before using the appliance.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
This appliance is designed for consumer use: follow the directions and use only as described.
This appliance contains no user-serviceable parts. If it suffers any failure or damage, cease usage and contact Kogan Support after consulting the Troubleshooting section of this manual.
Do not use the product in a high-temperature environment or where it may become wet or damp. If the unit becomes wet, do not use.
Stop using the product immediately if you feel uncomfortable or any abnormalities occur.
Do not use this product if you are currently pregnant or menstruating.
Do not place the unit in a place where it may be in contact with flammable items, explosive items, or chemicals.
Do not use this product if, you have any medical complication such as osteoporosis, a skin injury or disorder, low blood pressure, cancer or a pacemaker or other medical implant. Contact your physician before using this product.

Put on each massager, keeping your feet flat on the bottom. Note they are marked L and R for each foot.
Use the straps to tightly secure your feet and legs into the massager.
Move your foot to make sure that the massager is securely fastened.
Insert the two air pressure connections into the controller.
Press the power button when the LED screen is on.
Set the desired air pressure strength and mode.

Note

The device will automatically shut off after 20 minutes. For best results, do not use the leg massager for more than an hour.

<POWER> - Press and hold to power on. Press again to adjust intensity (LOW, MIDDLE and HIGH settings available). Press and hold to power off.
<MODE> - Select from Mode 1 Calf + Foot; Model 2: Calf; Mode 3: Foot.
<HEAT> - Switch foot heating on or off.

Problem	Cause	Solution
Device not working	Power not connected	Connect power
Device not working	Power button not pressed	Press power button
Device suddenly stops working	Device running for over 15 minutes	Restart to resume use