Solar Powered Motion Sensor LED 2 in 1 Spot Light - (NBLTWSLMSMA & NBLTWSLV2PA) - Manual

Safety and Warnings

• Do not dispose of the product or its batteries in a fire or they may explode.
• Do not disassemble the product by yourself.
• Do not allow the products to be immersed in water.

Overview

Operation

1. Press the “ON/OFF” switch at the back of the solar panel to turn on the light.
2. Install the light in an area where it can get direct sunlight. Charge the solar spotlight under direct sunshine at least 8 hours before using it for the first time.
3. The light will turn on automatically at night when motion is detected and turn off 30 seconds after motion stops.
4. The light will blink if the power of the battery gets too low. When it does, charge the light immediately.
5. During cloudy days or winter, charging time may be long and the working time may be short. This is normal for solar light products and does not indicate a fault.
6. If the ground is too hard, do not twist or hammer it with force. Try to soften the ground with water and then insert into the ground

Specifications

In The Box

2x Stake	1x Plastic Ground Spike	3x Expansion Plug	3x Screws