Safety & Warnings
- The device is not waterproof. Do not vacuum water or other liquids.
- In order to protect the vacuum and HEPA filter assembly from damage, keep away from:
- High-temperature objects such as cigarette butts, lit matches or hot ash, sharp objects such as glass or nails.
- Dangerous items and chemicals such as solvents, dirt remover, acids or detergents.
- Inflammatory or explosive liquids such as gasoline or alcohol.
- Check the dirt collector regularly and empty frequently to avoid clogging which can result in a suction decrease, engine overheating and reduced run time.
- If any sparks, overheating, unusual noise or other abnormal function is observed, stop using immediately and contact Kogan.com. Do not disassemble the product without assistance.
- Keep the vacuum away from fire and heat sources and avoid direct sunlight so as to prevent a fire hazard.
- Do not detach the dirt collector during operation. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Store safely and keep away from kids. This product is not a toy.
Overview
 |
 |
|
Front View |
Back View |
 |
 |
|
Suction Nozzle |
Dirt Collector |
Operation
Preparation
- Make sure all parts of car portable cleaner are installed.
- Check power is sufficient to run the product properly.
Charging Instructions
- Make sure the product is fully charged (every three months) prior to first use and after long storage.
- Plug one end of the cable into the cleaner and the other end into the socket
- Charging begins when the charging indicators flash and is completed when the indicators illuminate continuously.
Please unplug the power line in case of turn-on failure during the charging.
General Usage
Step 1
Remove the dust cover from the cleaner.
Step 2
Press the power button to turn on the cleaner: the power indicators will illuminate.
Setup is automatic. Press the power button again to turn off the cleaner.
Attachments
Connect the two-in-one retractable suction nozzle into the socket of the main body.
Use the vacuum to clean the areas of the house such as gaps and soft surfaces.
Cleaning & Care
Step 1
Remove the dirt collector by rotating as per the image below.
Step 2
Remove HEPA filter assembly from the dirt collector and empty it.
Step 3
Clean the dirt collector with a brush, tissue or wet wipe. Wash with water and use it after drying.
Step 4
Wash the filter with brush or tissue. Do not clean with water.
Specifications
|
Charging Duration |
1.5~2 hours |
|
Operation Duration |
>12 minutes |
|
Dirt Collector Volume |
0.1L |
|
Net Weight |
560g |
|
Noise Level |
<75dB |
|
Battery Capacity |
Li-ion 7.2V 2000mAh |
|
Nominal Voltage |
7.2V |
|
Rated Power |
80W |
Troubleshooting
|
Malfunction |
Possible Reasons |
Solutions |
|
Operation Failure |
Low power |
Recharge |
|
Not turned on |
Turn on the power |
|
|
Currently charging |
Unplug and restart |
|
|
Abnormal Functionality |
Dirt collector cup not in place |
Rotate into place |
|
Suction nozzle clogged |
Check and clean the suction nozzle |
|
|
HEPA filter clogged |
Clean the HEPA filter assembly |
|
|
Excessive Noise |
Dirt collector cup is full |
Empty |
|
Suction nozzle is clogged |
Check and clean the suction nozzle |
|
|
HEPA filter clogged |
Clean HEPA filter assembly |
|
|
HEPA filter assembly not in place |
Install HEPA filter assembly |
In the Box
- Two-in-one Retractable Suction Nozzle
- In-Car Charger
- Manual
- Dirt-collecting Cup & HEPA Filter Assembly (Pre-installed)
- Main Body