Safety and Warnings
- Keep your solar blanket & controller in a ventilated area and away from any liquids at all times.
- Keep the solar blanket and controller clean at all times(always check connectors to ensure they are clean before plugging them in).
- This appliance is not intended to be used by people (including children) with reduced physical or mental capabilities or those who are under the influence of drugs or alcohol.
- Do NOT use the solar blanket to charge non-rechargeable batteries. Doing so may result in harm to the user and/or damage the solar blanket and controller. (This product is for 12V batteries).
- Only use the provided solar blanket, regulator and adapters/wiring provided in the kit. Never tamper with or pull any component of the solar panel, regulator or wiring apart. If you do so, you will void the warranty.
- The controller is only applicable to some specified types of batteries. Please refer to the controller manual for details.
- The controller is only for this kit. Do not use it for another solar power system.
- Ensure no sharp or heavy objects that could potentially break or damage the solar blanket during transport or storage are placed near it.
Installation
Connection
 |
 |
 |
| Connect battery clips to the battery | Connect controller and battery | Connect the solar blanket with the controller |
Disconnection
 |
 |
|
Disconnect solar blanket and controller |
Disconnect controller and battery |
 |
 |
|
Fold up the solar blanket and store all accessories in the solar blanket front bag |
Disconnect battery clip from battery |
Operation
Icon / Buttons
- The menu button is used to switch the parameter display interface. Long press for 5 seconds to enter or exit parameter settings interface.
- The page up button enters the parameter setting interface. Press once to increase while in parameter setting interface.
- The page down/manual button switches battery output on or off when pressed lightly. Press once to decrease while in parameter setting interface.
Display Interface & Parameter Settings
Note :
- Press down while on 1)Home screen to switch battery output on/off.
- On 6) Working mode, 24H is constant, 1-23H is light + timing control mode and 0H is light control mode.
System Connection
- Connect the controller to the battery’s positive and negative terminals as per the diagram below : the controller will automatically detect the dynamic pressure of the battery.
- Connect the controller to the load’s positive and negative terminals as per the diagram below.
- Connect the controller to the solar module’s positive and negative terminals as per the diagram below.
Note:
- You must connect the components to the controller in the order specified above or malfunction or damage to the controller or battery may result.
- Disconnection order should be done in the opposite order: first disconnect the solar module, then the load and then the battery.
For optimal performance throughout the day, set the panel to approximately 30° from the ground. Anywhere between 10° and 40° will gain the best power absorption across the course of the day.
Troubleshooting
|
Fault |
Possible Cause |
Solution |
|
The controller shows no charge |
Components disconnected or the positive and negative connection is incorrect |
Reconnect the components to the controller |
|
No indication of load, no output |
The setup parameters incorrect |
Reset |
|
Battery power shortage |
Recharge |
|
|
Beeping with no loud output |
Load power overrated power |
Reduce power and press the page down button to recover |
|
Load output short circuit. |
Resolve short circuit and press page-down button recover |
|
|
Controller not illuminated. No drip after power-on |
Battery power shortage or positive and negative connection incorrect |
Replace the battery/check the connection of the battery |
In the box
 |
 |
 |
 |
|
Solar Blanket x1 |
Controller x1 |
Battery Clip x1 |
Extension x1 |