Safety and Warning
|Read the instructions carefully. Check no parts are
|Layout all of the components on a soft surface as if
you were preparing to do a jigsaw puzzle.
|Carefully identify each component, especially those
that are similar. The most common mistake is getting
things back to front
|Separate and identify each component from the
hardware pack and rest each one in its proper location
DO NOT fully tighten screws (leave slightly loose).
Do not use power tools as they may damage the
First, check that you have all of the parts necessary. The parts required for your chair
Place part “B” the bracket on the chair base, and add a washer, “D”, a spring washer
“E” and a nut, “F”. Repeat this for all sides:
Screw in the legs, and rotate your chair to the upright position: Note: The included spacers, marked “H” can be used to level the chair. To do so, remove the leg that requires extra height, and add a spacer in between. Fasten the leg again. Do this to any side that requires it.