Safety & Warnings
This product contains small items that could be a choking hazard if swallowed. Keep those items away from young children.
- Make sure these instructions are read and completely understood before attempting installation. If you are unsure of any part of this installation, please contact a professional installer for assistance.
- The desk or mounting surface must be capable of supporting the combined weight of the mount and the display otherwise the structure must be reinforced.
- Please check joint fasteners every two months and re-tighten if necessary.
- Never exceed the maximum load capacity of 12kg or else it may result in product failure or personal injury.
Note: This product is intended for indoor use only. Use of this product outdoors could lead to product failure or personal injury.
Overview
Part List
| No | List of Parts |
| 1 | Tube cover (2Pcs) |
| 2 | TV plate (1Pc) |
| 3 | Tube (1Pc) |
| 4 | The bottom support (1Pc) |
| 5 | Knob (1Pc) |
| 6 | Anti-slip rubber (2Pcs) |
| 7 | M6x6mm and 3x3mm (1Pc) |
Assembly
Step 1
Fitting the bottom support on the desk
 Attention |
Desk |
| Apply mount only to square-edged tables and desks. Do not use oddly shaped or curved-edge tables or desks to avoid the clamp from slipping. |  |
 |
Step 2
Installing the mounting arms
Step 3
Removing the mounting plates
Step 4
Connect the plate and monitor
Step 5
Install the monitor to the arm
Hang the monitor on the plate and ensure it is tightened.
Step 6
Adjusting the Screen
Use 5x5 wrench (G) to adjust screws in part 1 when the monitor is too tight or loose, use 5x5 wrench (G) to adjust screws in part 2 when the monitor is down.
Specifications
| VESA pattern | 75x75, 100x100 |
| Max load | 12Kg |
| TV Size | 17"-36" |
| Rotation | -85°-15° |