Safety and Warnings
Failure To Follow These Basic Steps Can Lead To Damage That Is Not Covered By Your Warranty
Read Instructions carefully. Check no parts are missing.
|Lay out all of the components on a soft surface as if you were preparing to do a jigsaw puzzle.|
|Carefully identify each component, especially those that are similar. The most common mistake is getting things back to front.|
|Separate and identify each component from the hardware pack and rest each one in its proper location before fastening|
|DO NOT fully tighten screws (leave slightly loose).When the item is fully assembled tighten the screws - but do not over tighten.|
|If glue is required DO NOT set until you are certain that the parts belong together.|
|Check your Components||Denotes Raw Edge or Surfaces|
In the interest of our environment please dispose of all packaging thoughtfully.