Safety & Warnings
- Read all instructions before using the product and retain for reference.
- Dispose of packaging with care. Small parts and packaging can pose a choking hazard.
- Supervise children at all times.
- Never allow the product to be ridden near steps, swimming pools or traffic.
- Never allow the product to be ridden near slopes or over rough or uneven surfaces.
- The maximum load should not exceed 55kg.
- Ensure the child sits leaning slightly forward to ensure balance.
- This appliance contains no user-serviceable parts. If it suffers any failure or damage, cease usage and contact Kogan Support.
 |
|
Parts
 |
 |
 |
 |
 |
 |
 |
| 1. Body | 2. Steering wheel assembly | 3. Front wheel assembly | 4. Rear wheels | 5. Steering wheel cap | 6. Hex key | 7. Foam sheath |
Not included, required: Rubber mallet, screwdriver or 17mm socket wrench
Assembly
 |
 |
 |
| Match the notch on each rear wheel housing to the body. Push the wheels in at a 45-degree angle. When installed correctly, the rear wheels will flare out from the body. WARNING: The rear wheel housing cannot be removed once locked into place. |
Strike the rear wheels with a rubber mallet to secure them in place. You can use a regular hammer, but if so, use a block of wood between the hammer and wheel so the wheel is not damaged. |
Get the front wheels. |
 |
 |
 |
| Guide the front wheel shaft through the body, into the foam sheath and through the hole at the top of the body. | Strike the base of the front wheel assembly with a rubber mallet. The metal bearing should be seated securely in the body. | Fit the steering wheel into the top of the front wheel assembly. NOTE: Ensure the bolt is attached to the steering wheel as shown. |
 |
 |
 |
| Align the steering wheel with the smaller front wheels so that wide end of the steering wheel faces forward. NOTE: When the front wheels are assembled and resting on a flat surface, the smaller front wheels should not contact the ground. |
This step is critical to the performance of the product: Use a 17mm socket wrench OR screwdriver+hex key to tighten the nut as tight as possible. |
Push the cap into the steering wheel. |
Troubleshooting
| Issue | Possible Cause | Steps to Resolve |
| Rear wheels detach | Product overloaded or subject to impact |
Fit wheel into housing so flat side of white clips contact wheel housing and snap wheel into place. Observe the maximum load weight. |
| The steering wheel is loose or does not propel product | Steering wheel nut is loose or not tightened sufficiently during assembly |
Remove the cap from the steering wheel with a slot screwdriver and loosen the nut with a hex key Repeat steps 7-8, securing nut as tightly as possible |