Safety & Warnings
Read the instructions carefully. Check that no parts are missing. | Lay out all of the components on a soft surface as if you were preparing to do a jigsaw puzzle. |
Carefully identify each component, especially those that are similar. The most common mistake is getting part back to front. | Separate and identify each component from the hardware pack and rest each one in its proper location before fastening. |
Do not fully tighten screws (leave slightly loose). When the item is fully assembled, tighten the screws but do not over tighten. Do not use power tools to assemble the unit. This may cause damage to the parts. |
If glue is required, do not set until you are certain that the parts belong together. |
Parts
Assembly
Step 1
Parts: 002C x8
Step 2
Parts: 007C x8, 008C
Step 3
Parts: 012C x4, 013C x12, 011C x2
Step 4
Parts: 001C x8, 008C
Step 5
Parts: 014C x8
Step 6
Parts: 005C x4, 006C x4
Step 7
Parts: 003C x16, 004C x4
Step 8
Parts: 009c x12, 010C x12
Assembly is now complete!
Adjusting Door Gaps
These are optional steps to make any gaps around the doors more even.
Step 1
Open the door.
Step 2
To adjust the gap between the door panel and side panel, loosen the indicated screw a bit, and adjust the hinge to the right position (see steps 2a and 2b), then tighten the screw.
2a: push the hinge back a little.
2b: pull the hinge forward a little.