Assembly Instruction
Place shelter in the centre of the area to be sheltered. Remove cover and have 2 people standing on the opposite sides, grasp two outer legs off ground and step backwards, stopping at arm's length.
Grasp the bottom of the diamond (shown), on opposite sides, lift and step backwards until shelter is fully opened; be careful not to pinch fingers.
Grasp at bottom of the diamond (shown), lift and step backwards at the same time until shelter is fully opened, be careful not to pinch fingers at the end of the truss.
Engage the auto slider at each corner by pushing up with one hand while holding down top of leg with the other hand, snap button will engage in groove. Repeat on all other legs.
Lift two adjacent outer legs up and pull out the inner legs until snap locks. Repeat on all legs. Raise or level the shelter using adjustment holes found near the bottom of each outer leg.
Move the valance material upwards and connect the Velcro of the wall on to the Velcro of the frame. Loop the Velcro tabs on the top truss bar to secure the wall.
Repeat the last step to install each side. Then, put each sidewall together using the Velcro. The Velcro is sewed on both sides of every valance material.
The door is in the front. There are two zippers on the front valance. Unzip it, roll the valance up. People can walk into this tent.