Certa Multi-Stage High Pressure Water Pump - (CTMSHPWPMPA) - Manual
Safety & Warnings
Read all instructions before using the appliance and retain for reference.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Before beginning work, ensure appropriate electrical safety measures are in place, with a proper ground wire system and circuit breaker safety device installed or verified by a qualified professional.
Be careful of using at a height 1000m or more above sea level.
Use with a clean, non-chemically corrosive liquid such as water with a pH level between 5 and 8.
This manual is for reference only and may differ in minor ways from successive iterations of the product.
This appliance contains no user-serviceable parts. If it suffers any failure or damage, cease usage and contact Kogan Support after consulting the Troubleshooting section of this manual.
Notes on Usage
The pump is intended to be used in outdoor fountains, garden ponds and similar places.
Anchor with M8 or M10 bolts. In water, support separately.
Use durable steel pipe or hose to connect the bottom valve and pump inlet. Fill the pump cavity and inlet pipe with water. When using a hose, ensure the temperature does not deform the hose and cause leaking.
To avoid leakage, seal suction lines and connections. Outlet pipe connection should be firm to prevent splashing on motor parts and frequent pump engaging.
After the upper end of the water inlet pipe is connected to electric pipe inlet, ensuring the lower end of the water inlet pipe and bottom valve are not immersed.
Ensure pipe installation is as short as possible with as few joints as practical. Suction height must not exceed electric pump suction range.
Monitor water level drop and do not expose the bottom of the unit, or the bottom of the inlet pipe.
Install pump as straight as possible above well. When pump can only be installed far away from water, maximum length of tune from well depends on suction process. The suction level is based on data at dry season.
Ensure that the two shorter power leads on the unit are connected to one another before connecting the longer power cable to a wall outlet, as shown in the images below: