Parts Included
Assembly
Step 1:
Lay parts; M4, M8, M5 on the ground and place them in "±" shape displayed in the image below.
Step 2:
Attach M9 to the horizontal cross members M4 and M5 using the L2 screws from side, shown in the image below.
Step 3:
Place the hinge in the center of the upper cross and fix it in place to M8 using the LI screws. Note: There are no predrilled holes for the screws.
There are holes for a bolts in the side of M7 rear leg. Place the top of M7 in the hinge as picture below and fix in place using the L3 bolt.
Fix M7 at an angle to make the frame stand up and fix it in position using M5 and the L5 bolts as pictured below.
Step 4:
Fix the upper clamp, M2, and the tray, M6, into position using the L4 bolts through the M3 clamps as shown in the images below.
The easel is now complete