Kogan SmarterHome Smart Aroma Diffuser - (KASHSMARDFA) - Manual

Safety & Warnings

• Do not attempt to transform, disassemble, or repair the product. If the product needs to be repaired, contact kogan.com.
• Do not damage the power cable in any way. Stop using the device if there is any damage to the power cord.
• Do not carry the device by the power cord.
• Do not use the device and power adapter in a wet area such as bathroom, dressing room, greenhouse, etc.
• Make sure the device is kept clean. After using the product drain the water out of the water tank, and use a cloth to wipe it clean.
• The essential oils utilised may cause staining if spilled. Clean immediately if spilled.
• Do not fill from the tap directly. Use the measuring cup to add water into the water tank.
• Don't let the spray nozzle spray directly on furniture, clothes or walls.
• Avoid placing the device in direct sun light, close to an air conditioner, fan or high temperature appliances.
• Install the unit on a flat level surface.
• Avoid placing the device near other electronics.
• Don't block the mist outlet.
• Only use clean tap water.
• Do not move the device while it is operating.
• Don't touch the product while your hands are wet, in order to avoid electricity shock.
• Place the product out of the reach of children and pets.

Overview

 Part List :

A. Mist Outlet
B. Upper Cover
C. Water Tank Cover
D. Air Outlet
E. Water Tank
F. Base
G. Light Button
H. HIGH / LOW/Wi-Fi Button
I. Mist Button
J. Air Intake
K. DC Socket
L. Water Outlet

Operation

1. Remove the upper cover. (FIG 1)
2. Connect the AC adaptor to the DC socket on the base. (FIG 2)
3. Using the measuring cup, fill the water tank with tap water up to the max water level line.
- Do not overfill or mist output may be low.
- Do not use hot water.
- Never fill in water during operation.
- Drop essential oil into water tank vertically. (About 0.1ML-0.15ML per 100ML water) (FIG 3) 
4. Replace the upper cover onto the base. (FIG 4)
- The upper cover must be in place during operation.
5. Connect the AC adaptor to a power outlet.
6. Right Side Button - Mist Button:
a. 1st Press: Timer set for one hour of continuous mist.
b. 2nd Press: Timer set for two hours of continuous mist.
c. 3rd Press: Timer set for three hours of continuous mist.
d. 4th Press: Continuous mist will turn off when water level becomes too low.
e. 5th Press: Turn off the mist. (FIG 5)
7. Left Side Button - Light Button:
a. 1st Press: Soft rotating colour
b. 2nd Press: Freeze current colour
c. 3rd Press: Turn OFF.(FIG 6)
8. Middle Button - HIGH / LOW Mist:
The diffuser outputs at high mist mode by default. Press to switch to low mist mode.
9. Middle Button - Wi-Fi:
Pressing middle button for 5-8 seconds, the white tight will start flashing fast.
The white tight will stop flashing when successfully connected of Wi-Fi.
10. The unit turns off automatically when the water level reaches its lower limit.

Note:

• The diffuser will not work without water.
• The amount and intensity of mist produced will vary, but this is not unusual and should not be considered as a fault. Factors that affect this include water type, humidity, temperature, air currents.
• It is recommended that the device is cleaned every time is oil is changed.
• Oils are corrosive, and over time, they build up on the atomizing plate.

Accidental Leakage

In the event of the unit being knocked over or tipped during usage, please follow the instructions as below:

1. Unplug the unit and remove the cover.
2. Pour out any remaining water out of the water tank.
3. Shake the unit gently to drain any water inside the mechanism, and then allow drying for at least 24 hours.

Application

Add the device to APP
Download and launch the "TuyaSmart" APP.
Make sure that your phone is connect to Wi-Fi
(This device only supports 2.4GHz Wi-Fi, doesn’t support 5.0GHz)

Amazon Alexa Control

Refer to the Amazon Alexa manual for creating a amazon account.
(Amazon Alexa and TuyaSmart need to be authorized under the same WiFi. This device only supports 2.4GHz WiFi, doesn’t support 5.0GHz)

Maintenance

After using 5-6 times, or for 3-5 days, please clean the product as below.

1. Unplug the unit from power supply and remove the cover.
2. Pour out any remaining water out from the “DRAIN SIDE” of the water tank.
3. Add some warm water into tank and mix with neutral detergent, wash with a cleaning cloth.
4. If you find any dirt in the air outlet, please remove the container cover and clean it.
5. Never use other acids, enzymes or detergents, as this may risk poisonous gas to be created or cause malfunction.

Troubleshooting