This manual applies to products: | |
OVBEDGCLDGB |
Ovela Bed Frame - Calabria Gas Lift Collection (Grey, Double) |
OVBEDGCLQGB |
Ovela Bed Frame - Calabria Gas Lift Collection (Grey, Queen) |
OVBEDGCLKGB |
Ovela Bed Frame - Calabria Gas Lift Collection (Grey, King) |
OVBEDGFLDBB |
Ovela Bed Frame - Florence Gas Lift Collection (Black, Double) |
OVBEDGFLDWB |
Ovela Bed Frame - Florence Gas Lift Collection (White, Double) |
OVBEDGFLQBB |
Ovela Bed Frame - Florence Gas Lift Collection (Black, Queen) |
OVBEDGFLQWB |
Ovela Bed Frame - Florence Gas Lift Collection (White, Queen) |
OVBEDGFLKBB |
Ovela Bed Frame - Florence Gas Lift Collection (Black, King) |
OVBEDGFLKWB |
Ovela Bed Frame - Florence Gas Lift Collection (White, King) |
Assembly Instructions
Bed Fittings
Part List
Assembly
Step 1
Attach 8 x bolts ① to the brackets by using the Allen key ② as shown, do not tighten the bolts, keep them 8 mm loose. Attach side rails (C, D) to the headboard (A) and footboard (B) over the bolts as shown. Do not fully tighten until step 4.
Step 2
Attach cross rail (E) to side rails (C, D) with 4 x medium screws .
Step 3
Stick the felt pads ⑤ to brackets ④, then attach to side rails (C, D) as shown. Tighten the bolt ③.
NOTE: ONCE BED IS ASSEMBLED, NEVER SIT, STAND OR APPLY WEIGHT DIRECTLY TO SLATS UNLESS MATTRESS IS IN PLACE. |
Step 4
Loosen the nut and washers on the bottom of rod bracket, attach the gas lift to the bottom of rod bracket using the bolt, then tighten the nut and washers. The bolt on the top of the gas lift is adjustable if the nut and washers on the bottom of rod bracket can't be fitted.
Step 5
Attach slat frame (F) to mechanism + piston (C, D) using 6x bolts ⑦, 6 x nuts ⑧ and 12 x washers ⑨. tighten the bolts and nuts on slat frame (G) and mechanism + piston (C, D) using an allen key ② and spanner ⑩.
Step 6
Attach the belt ⑥ to slat frame (F).
NOTE: ONCE BED IS ASSEMBLED, NEVER SIT, STAND OR APPLY WEIGHT DIRECTLY TO SLATS UNLESS MATTRESS IS IN PLACE. |
Step 7
Attach the support leg ⑪ to slat frame (F) using 2 x bolts ⑫, 2 x nuts ⑧ and 4 x washers ⑨ Tighten the bolts and nuts using a spanner ⑩.
Step 8