Safety & Warnings
- Use within an ambient temperature of 0-40°C
- Unplug the power plug before cleaning: wipe the dust on surface with a damp cloth, no corrosive or abrasive materials and take care not to let water contact the internal parts, or loosen the connectors.
- Parts of this product should be disposed of in accordance with council regulations, not general household waste. The control box contains electronic components, metals, plastics, wires etc.
- Check carefully to ensure correct and complete assembly before using.
- Be familiar with all functions and program settings of the product before first use.
- Do not allow children to play with the product or use without supervision.
- Slight noise produced by the V-ribbed belt or brake system is normal.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Ensure the working environment is clean and free of obstructions or hazards.
- It is recommended to keep the original package of the equipment if necessary in case of the future use in transportation or warranty service.
Parts Included
Note: The images above are for reference only and the appearance of the parts may vary. If there are any missing parts you have any issues with installation, contact Kogan.com.
Assembly
Operation
- Press UP button or DOWN button to lift or lower the height of desk surface.
Saved Height Positions
- Press the UP button or DOWN button to lift or lower the height of desk surface. For instance, adjust the height to 80cm.
- Press "M" SAVE button and the LED display will show: -S
Then press "1" to save the 1st height position as 80cm. The LED display will show: -SI - Repeat steps A and B to save the 2nd and 3rd height positions. The LED display will show: -S2 and then -S3
- Press "1", ”2", "3", to automatically reach the height saved before.
Reminder Function
- Press REMINDER button "A" to activate the function. The LED display will show: ON
- After 2 seconds, the display will flash: press
to adjust the reminder time. The system will save this time after 5 seconds, or you can press any button to confirm. During operation, any commend will restart the timer. When the countdown finishes, the buzzer will sound for 10 seconds.
- Press any button while the buzzer is sounding to restart the countdown. If it finishes, it will set another reminder for 5 minutes. If it finishes again, the Reminder function will switch off.
- Press and hold the "A" button for three seconds to turn off the Long-Time Sitting Reminder. The LED display will show: OFF
Troubleshooting
Issue |
Steps to Resolve |
No response when pressing buttons |
Check all connections including power |
Rising speed is low |
Confirm not overloaded: maximum load is 100kg |
Motor not working |
Contact Kogan.com |
Goes down but not up |
Reposition desk and accessories |
Slides downward |
Confirm not overloaded: maximum load is 100kg |
Re-positions itself |
Confirm not overloaded: maximum load is 100kg |
Errors, overworked |
Turn off and restart after 20 minutes |
Will not adjust to correct height |
Press "M” and “3” together for 3 seconds to restore factory settings. The desk will beep twice to confirm. |