Warning
Failure To Follow These Basic Steps Can Lead To Damage That Is Not Covered By Your Warranty
![]() |
Read Instructions carefully. Check no parts are missing. |
![]() |
Lay out all of the components on a soft surface as if you were preparing to do a jigsaw puzzle. |
![]() |
Carefully identify each component, especially those that are similar. The most common mistake is getting things back to front. |
![]() |
Separate and identify each component from the hardware pack and rest each one in its proper location before fastening. |
![]() |
DO NOT fully tighten screws (leave slightly loose).When the item is fully assembled tighten the screws - but do not over tighten. |
![]() |
If glue is required DO NOT set until you are certain that the parts belong together. |
Door Adjustment
Door adjustment is optional and is only required to decrease the gap between the doors and cabinet
Step 1
Open the door.
Step 2
Adjust the gap between door panel and side panel.
Loosen the screw indicated a little, adjust the hinge to right position (see step 2a & 2b), then tighten the screw.
Step 2a
Move door in
Push the hinge back a little.
Step 2b
Move door out
Pull the hinge forward a little.
Step 3
To adjust the gap between two door
Loosen or tighten the screw indicated a little to adjust the gap between doors panels (see step 3a & step 3b)
Step 3a
Move door right
Turn the screw clockwise a little as shown to make the gap small.
Step 3b
Move door left
Turn the screw counterclockwise a little as shown to make the gap big.
Assembly
Tools Required