WARNING
FAILURE TO FOLLOW THESE BASIC STEPS CAN LEAD TO DAMAGE THAT IS NOT COVERED BY YOUR WARRANTY
 |
Read Instructions carefully. Check no parts are missing. |
 |
Lay out all of the components on a soft surface as if you were preparing to do a jigsaw puzzle. |
 |
Carefully identify each component, especially those that are similar. The most common mistake is getting things back to front. |
 |
Separate and identify each component from the hardware pack and rest each one in its proper location before fastening |
 |
DO NOT fully tighten screws (leave slightly loose).When the item is fully assembled tighten the screws - but do not over tighten. |
 |
If glue is required DO NOT set until you are certain that the parts belong together. |
Assembly
Door Adjustment
Door adjustment is optional and is only required to decrease the gap between the doors and cabinet
STEP 1.
Open the Door
STEP 2.
Adjust the gap between door panel and side panel
Loosen the screw indicated a little, adjust the hinge to right position (see step 2a & 2b), then tighten the screw.
STEP 2(a) MOVE DOOR IN
Push the hinge back a little
STEP 2(b) MOVE DOOR OUT
Pull the hinge forward a little
STEP 3
To adjust the gap between two door
Loosen or tighten the screw indicated a little to adjust the gap between doors panels (see step 3a & step 3b)
STEP 3(a) MOVE DOOR RIGHT
Turn the screw clockwise a little as shown to make the gap small
STEP 3(b) MOVE DOOR LEFT
Turn the screw counterclockwise a little as shown to make the gap big.
