Safety & Warnings
|
Handle with care and inspect regularly to ensure product is in good working order. If this product, power supply cord or plug shows any signs of damage: stop use, unplug the product and contact Kogan.com support. |
General Safety Instructions
|
Risk of electric shock. DO NOT OPEN! Do not attempt to service the television yourself, as opening or removing the covers may expose you to dangerous voltage or other hazards. Refer all servicing to the Kogan customer support team. |
 |
|
To reduce the risk of fire or electric shock, do not expose this product to rain or moisture. The television should not be exposed to dripping or splashing and no liquid filled objects such as vases should be placed on the case. |
 |
|
In the event of smoke, strange noises or a strange smell from the unit, you should follow these steps:
|
 |
| Never push objects of any kind into the set through the cabinet slots as they may touch dangerous voltage points or short-circuit parts that could result in a fire or electric shock. Never spill any liquids onto the set. Use special caution in households where children are present. The television is not suitable for children under 4 years old to operate. |  |
|
Power supply cords should be routed safely to prevent dangers due to damaged cords. The mains plug is the main disconnect method, so it should be easily accessible and not be obstructed during use. |
 |
| To avoid fires, no naked flame sources such as lit candles or burning incense should be placed onto the casing of the television. |  |
| Do not pull the plug out of a power outlet by pulling on the power cable. Always grasp the plug and pull. Never touch the plug with wet hands. |  |
| An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits, as contact with them may be fatal. |  |
| Always turn the set off when it is not being used. Unplug the television from the power outlet when it will not be used for a long time or when there is an electrical storm. Never touch the antenna cable during a lightning storm. |  |
| Excessive volume from earphones and headphones can cause permanent hearing loss. Always monitor the volume of noise from these devices, especially when children are using them. |  |
Installation
 |
Ventilation should not be impeded or limited by covering the ventilation slots with items such as newspapers, tablecloths, curtains etc. At least 10cm of space should be left around the apparatus for sufficient ventilation. |
 |
The television should be situated away from heat sources such as radiators, heaters, stoves or other products that produce heat. Place the television in a position where the screen is not exposed to direct sunlight. It is best to have soft indirect lighting while watching and you should avoid a completely dark viewing environment and reflections to avoid eye fatigue. Keep the product away from high magnetic fields (such as near an amplifier speaker) to avoid affecting the tint. |
 |
Do not place the television on an unstable table, stand or shelf. The set may fall, causing serious injury as well as damage to the television itself. If moving the television on a cart, move the unit with care as sudden stops and starts may cause the television to overturn. |
 |
Do not place this television near water, for example near a bathtub, wash bowl, kitchen sink, laundry tub, swimming pool or in a damp basement etc. |
 |
When moving the television to a warm location from a cold location, allow some time for any dew or condensation inside the television to evaporate fully before you turn the unit on. |
 |
To prevent injury, the television must be securely attached to the floor/wall in accordance to the supplied installation instructions. |
Cleaning
|
Unplug the television from the power supply before cleaning. Do not use any liquid cleaners or harsh chemicals. Use a soft, damp cloth. |
 |
Product Overview
Button Functions
- POWER: Turn on TV/Standby
- SOURCE: Audio/Video input source selection
- MENU: Open settings menu
- VOL-: Decrease volume
- VOL+: Increase volume
- CH-: Previous channel
- CH+: Next channel
- IR RECEIVER: Receives infrared signals from the remote control
- INDICATOR LED: Status indicator
Assembly Instruction
Note: Please use the recommended screw size for installation of wall mounts to avoid damaging the screen.
VESA approved wall mounting bracket (NOT SUPPLIED).
The VESA mounting pattern is 200x200mm
Mount the VESA bracket using 4 x M6 x 10 isometric threaded screws (not supplied). Do not use screws longer than 10 mm; damage will occur to the internal components.
Port Diagram
| This LED TV has digital multimedia performance and can be connected to multiple external devices. The following diagram presents the connections to other video and audio appliances. |
| # | Item | Description |
| 1 | COAXIAL | Connect the SPDIF receiver. |
| 2 | Audio L/R | Audio input. |
| 3 | Video | Connect video output from a DVD or VCR. |
| 4 | YPbPr | Connect to the YPbPr video output terminal of the DVD. |
| 5 | Headphone | Connect the earphone. |
| 6 | HDMI | Digital signal input from HDMI video connector. |
| 7 | RF | Connect an antenna or cable TV cable to this jack. |
| 8 | USB | The USB is for Service. |
Remote Control
- POWER: Turn on the TV/Standby.
- AUDIO: Switch the audio channel when DVD
or multimedia playing.
I/II: In the TV condition, press this button to select the stereo mode. - SLEEP: Auto Power Off Timer.
- SUB: Select subtitle of media video file. (needs the support of disk or flie)
- FAV: Show the list of favourite channels.
- NUMBER KEYS: Change the channel directly.
- DTV/RADIO: In DTV mode, press DTV/RADIO button to enter DTV or RADIO mode.
: Return to the previous channel tuned.- MUTE: Mute or restore the sound.
- VOL: Increase and decrease volume.
- CH: Next and Previous channel.
- REPEAT: Repeat mode.
- INFO: Show information about the current program.
- SOURCE: Press to change signal source.
- NAVIGATION KEYS (Up, Down, Left, Right and OK): To move in the menus and confirm settings.
- MENU: Display menu page.
- EXIT: Exit the Menu.
- P.SIZE: Press to select the different picture size.
: Displays the main index in Teletext mode. - GUIDE: Show the Electronic Program Guide.
: Reveals hidden information such as the answers to a quiz in TELETEXT mode. - S.MODE: Setting audio options.
: Freeze a multi-page changing on Teletext mode. - P.MODE: Output image mode selection.
: Displays the top, buttom or all of page. 
: Play/Pause.
TS: In DTV mode, press TS button to start the delay function, press the button to start playing delay program, press the 
button to terminate the delay functions.- : Stop playback.
- TXT: Turns on and off the Teletext function.
GOTO: Play from the desired location. - REC/
: In DTV mode , press REC button to start recording, press button
to stop recording. 
: Previous file or chapter.
: Next file or chapter.
: Fast forward playback.
: Fast rewind playback.
Press the appropriate colour to direct access functions in TELETEXT or EPG OSD mode.
|
Signal Type |
Infrared |
|
Control Distance |
8 meters |
|
Control Angle |
30° (Horizontal) |
|
Power Supply |
AAA 1.5V x 2 |
Install the Batteries
If the remote control fails to operate the TV functions, replace the batteries in the remote control.
- Open the battery cover.
- Insert two size-AAA batteries. (Place the batteries with their terminals corresponding to the (+) and (-) indications in the battery compartment.)
- Replace the cover.
Operation
Initial Setup
- Connecting your TV on the poweroutlet;
- Press the POWER button on the remote to turn on the TV in green for the LED light.
CAUTION:Always disconnect the TV from the power outlet when the TV will not be used for a long period of time. The POWER button on the front panel is only used for switching the TV into standby, it does not disconnect the device from the main voltage. To completely disconnect the main voltage, please remove the power plug from the socket. - Press the key▼/▲/◄ / ►and following the picture as bellow to operate the subject.
NOTE:
The picture is for reference only.
Pay attention:Press the▼/▲ /◄ / ►button to use and operation and press OK to finish.
Select Input Source
Press SOURCE button to display the input source list, Press ▼/▲ or SOURCE button to select the input source you want to, Press OK button to enter the input source, Press EXIT button to quit.
Basic Operations
- Press the MEMU button on the remote control, the on-screen menu will appear on the screen.
- Use the ◄ / ► buttons to select your main menu option.
- Use the ▼/▲ buttons to highlight your color temp option, use the ◄ / ► buttons to
change the setting. - And press the MENU to exit the menu.
Main Menu Operation
Channel Menu
Press MENU button to display the main menu.
After finishing your adjustment, Press MENU button to return back to the previous menu.
Tuning Steup
DTV Manual Tuning
ATV Manual Tuning
Programme Edit
The three colored key are the shortcut key for programming the channels. First press ▼/▲ button to highlight the channel you want to delete or move or skip, then:- Press the Red button to delete the channel.
- Press the Green button to enter the rename state, then press◄ / ► to select the word you
want to change, and ▼/▲ to select word. - Press the Yellow button to skip the select channel.
(Your TV set will skip the channel automatically when using CH+/- to view the channels.) - Press the Blue button to to set the channel to moving state. then press ▼/▲ to move it to the position you want to put,and press Blue button again to done the move operation.
Signal Information
Only available when there is signal under DTV.
After finishing your adjustment, Press MENU button to return back to the previous menu.
Picture Menu
Press MENU button to display the main menu.
After finishing your adjustment, Press MENU button to return back to the previous menu.
Sound Menu
Press MENU button to display the main menu.
Sound Mode
- Press ▼/▲ button to select Sound Mode, then press Enter button to enter sub-menu.
- Press▼/▲ button to select.
After finishing your adjustment, Press MENU button to return back to the previous menu.
NOTE:
Balance: This item can adjust the speaker ’s output, it enables you to listen to best at your position.
AVL: This item uses for reducing the difference between channel and program’s
volume automatically.
It made the overall water to be even. This function will also reduce the fluctuation of the sound.
Time Menu
Press MENU button to display the main menu.
OPTION Menu
Press MENU button to display the main menu.
After finishing your adjustment, press MENU button to save and return back to the previous menu.
OSD Language
Select an OSD menu language can be displayed.Default English is selected as menu language.
Audio Languages
Select an audio language can be displayed.
Subtitle Language
Select a subtitle language can be displayed.
Aspect Ratio
Blue Screen
Press ▼/▲ button to select Blue Screen, then press Enter button to select On or Off.
First Time Installation
Press ▼/▲ button to select First time installation, then press Enter button to enter.
Reset
Press ▼/▲ button to select Reset, then press Enter button to enter sub-menu.
Software Update(USB)
Press ▼/▲ button to select Software Update (USB), plug your USB device in the USB slot, then press Enter button to update the right software.
HDMI CEC
Press ▼/▲ button to select HDMI CEC, then press Enter button to enter the sub-menu.
Lock System Menu
Press MENU button to display the main menu.
Default password is 0000,and if forget what you set, please call the service center.
Media Operation
Note: Before operating USB menu,Plug in USB device, then press SOURCE button to set the Input Source to MEDIA.
Press ◄ / ► button to select MEDIA in the Source menu, then press OK button to enter.
 |
Press to play or pause. |  |
Press to play the previous song. |
 |
Press to play the next song. |  |
Press to play backward. |
 |
Press to play faster. |  |
Press to stop. |
Photo
Music
Press CH+/- to switch operation focus between File List and Player.
Movie
Text
When highlighting the option you select, the file information will appear on the right
Troubleshooting
Refer to the help article 'TV Troubleshooting Guide' for detailed information with any issues you may be having with your TV.
Alternatively, you are welcome to contact our Support Team with any queries - please note that a photo or video of the issue can assist with identifying and resolving the issue.