Kogan HD-30 Pro Headphone (Black) - (KA30HEADPBA) - Manual – Kogan.com Help Centre

Safety & Warnings

Read all instructions before using the product and retain for reference.
If you have a cardiac pacemaker or other electronic medical equipment, you should consult your physician before using this product.
This product contains small parts and packaging which may pose a choking hazard. Keep out of reach of children.
This appliance is designed for consumer use: follow directions and use only as described.
Always drive safely, avoid distractions and follow required laws.
Permanent hearing loss may result from long-term exposure to sound at high volumes. Always set the volume to as low a level as possible. Adjust slowly if increasing volume is required. Avoid using earphones for extended periods of time.
If you experience discomfort or ringing in your ears, stop use immediately. With continued use at high volume, your ears may become accustomed to the sound level, which may result in permanent damage without noticeable discomfort.
This appliance contains no user-serviceable parts. If it suffers any failure or damage, cease usage and contact Kogan Support after consulting the Troubleshooting section of this manual.

Press and hold the Multifunction Button (MFB) for 6 seconds until the LED indicator flashes red and blue, indicating it is in pairing mode.
Turn on Bluetooth on your device, locate the earphones and pair to them in Bluetooth settings.
When successful, the LED indicator will flash blue.
If prompted for a password, enter 0000.

Note: The earphones will reconnect automatically. If they do not, press MFB once or reconnect through Bluetooth.

Issue	Resolution
Indicator blinking red quickly	• Low battery - charge headphones
Not turning on	• Battery depleted - charge headphones before starting
No indicator when charging	• If the battery has been depleted or has not been turned on for a long time, the charging indicator may take a few minutes to illuminate
No sound over Bluetooth	• Ensure Bluetooth is switched on and connected. • Check sound output is headphones in device Bluetooth settings • Ensure distance is within 10 meters. • Check for without external interference. • Ensure device is not connected to other sound outputs through Bluetooth or headphone jack.
No sound while wired	• Check the audio cable is inserted correctly and secure • Ensure device’s headphone jack works correctly.
Cannot connect to Bluetooth	• Turn headphones off and on again • Switch Bluetooth off and on again in device settings • Ensure headphone and device’s Bluetooth are turned on. • Ensure headphones are in Bluetooth pairing mode with indicator illuminated.