Safety & Warnings
Handle with care and inspect regularly to ensure product is in good working order. If this product, power supply cord or plug shows any signs of damage: stop use, unplug the product and contact Kogan.com support. |
- Read all instructions before using the appliance and retain for reference.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Do not allow children to play with the appliance. Do not cleaning or perform maintenance shall not be made by children without supervision.
- This appliance is designed for consumer use: follow directions and use only as described.
- Do not use with an extension cord unless necessary, and if so, ensure it is suitably rated and it is handled safely as is the product's own power cord.
- Do not allow the power cord to be exposed to water, heat, direct sunlight or overhang where it can be pulled or otherwise be damaged or pose a hazard.
- Keep the machine at least 1.7M away from any water or fire source at all times, whether the machine is in use or not.
- Only clean with a damp cloth, Do not rinse or put water onto or into the machine.
- Do not use for longer than 360 minutes. Leave for an interval of 30 minutes.
- Ensure clothes have been spin-dried or hand-wrung well to reduce water dripping onto the machine and the floor. This will also reduce drying time and save more energy.
- Never touch metal parts or fan outlets as they will be very hot and can burn.
- All fabrics and materials put into the machine should be able to endure temperatures up to 85 degrees. Never put flammable materials into the machine.
- Fan/air outlets and entry points on the motor units must be kept clean at all times to allow good ventilation. Do not allow any materials or fabric to touch fan/air outlets.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. This appliance contains no user- serviceable parts.
WARNING: This appliance is intended only for drying textiles washed in water.
WARNING: Do not use plastic coat hangers in the dryer.
Specifications
Rated Voltage | AC 23O-24OV |
Rated Power | 1000W |
Rated Frequency | 50HZ |
Rated clothes capacity | <=10kgs |
Overview
Parts
Part |
Qty |
A. Hanging rack |
1 |
B. Supporting tube |
2 |
C. Screw connector |
1 |
D. Cloth cover |
1 |
E. Waterproof plate |
1 |
F. Motor unit |
1 |
G. Standing tube |
3 |
H. Feet |
3 |
Installation & Disassembly
1. Insert 3 standing feet into the corresponding holes on the bottom of the motor unit.
2. Insert the lower supporting tube into the motor unit, then screw it clockwise into place.
3. Fit the screw connector onto the upper supporting tube (hanging rack) and screw it clockwise until it reaches position.
4. Put on the cover and close the zipper.
NOTE: Ensure the bottom cover aligns with the motor unit and there is no air leakage
To disassemble this machine, follow the installation steps in reverse.
Operation
- Insert the power plug into the power socket.
- Rotate the control knob: the indicator will illuminate and the machine will start to work.
- Rotate the knob counter-clockwise to work without a time limit.
- Rotate knob clockwise to set a time (up to 180 min).
NOTE: The off position is when the indicator is facing towards the air outlet.
Troubleshooting
Issue |
Possible Cause |
Connected power and rotate the knob, Indicator not illuminating |
1) Power has been cut. 2) Plug is loose. |
Drying time too long(>180mins) |
1) Clothes packed too tightly. 2) Clothes too wet. 3) Cover not closed properly. |
Machine suddenly stopped working |
1) Fan or air outlet/inlet blocked or covered, triggering shutdown protection. 2) Set time exceeded. |
Abnormal noise |
1) Air inlet blocked. |