Kogan 3D Printing Pen (KA3DRAWPENA) - Manual

Safety & Warnings

• Read all instructions before using the appliance and retain for reference.
• Adult supervision is required for use by children.
• The nozzle tip will reach high temperatures during use and can cause burns if touched. Not suitable for children under 5.
• Always wear the included finger grips to avoid injury caused by the nozzle tip.
• Do not hit the nozzle tip on any hard objects.
• Do not insert any other material into the filament loading hole.
• Do not exceed the filament diameter tolerance of +/- 0.02mm.
• Unload filament after each use.
• Do not allow the pen to become wet.
• Use only the original supplied USB power cable.
• This appliance contains no user-serviceable parts. If it suffers any failure or damage, cease usage and contact Kogan Support after consulting the Troubleshooting section of this manual.

CAUTION: Use only PCL filament with this product.

Overview

Included

• Pen
• USB cable power cord
• Finger grips
• 2x 1.5m filament (blue + pink)

Operation

1. Connect power to 3D Pen: Connect the power cable from a USB power supply (not included) and to the pen’s 3.5mm power socket. The pen will go into standby.
2. Put on finger grips in order to avoid injury when using the product.
3. Start printing: By pressing “ON/OFF/Speed” Button, the nozzle will start heating and the display will show current and set temperature. The set temperature will be reached within 30 seconds (±31°C). Speed will default to "High" speed.
4. Loading filament: Insert filament into the filament loading hold, press “load/inject” button. Click once for manual injection or double-click for automatic injection.
5. Speed adjustment: Pressing the speed button to cycle between low, medium and high speed.
6. Unloading filament: In order to avoid blocking the nozzle, do the following before unloading:
   • Press Load/Inject button to draw out melted filament from the tip.
   • Press Unload button to upload and press for another 2 seconds to stop.

Note: The pen will go into standby after 3 minutes without use. Press on/off to wake.

Filament Preparation

Troubleshooting