Safety & Warnings
Handle with care and inspect regularly to ensure product is in good working order. If this product, power supply cord or plug shows any signs of damage: stop use, unplug the product and contact Kogan.com support. |
- Read all instructions before using the appliance and retain for reference.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Follow all directions and only operate as part of indoor household use.
- Do not use with an extension cord unless necessary, and if so, ensure it is suitably rated and it is handled safely as is the product's own power cord:
- Do not allow the power cord to be exposed to water, heat, direct sunlight or overhang where it can be pulled or otherwise be damaged or pose a hazard.
- Do not touch exposed cables with your bare hands when operating the appliance or touch the plug while your hands are wet.
- DC power source installation (for example, in a boat) should be handled by qualified personnel. Ensure the electricity source has a fuse if using mains power.
- Do not place any electrical devices inside the refrigerator.
- Do not allow the appliance to be exposed to water.
- Keep the appliance away from substance, which can cause ignition.
- The appliance is not intended for use by young children or infirm persons unless they have been adequately supervised by a responsible person to ensure that they can use the unit safety.
- Young children should be supervised to ensure that they do not play with the appliance.
- Never place hot food or drink in the appliance.
- Before disposing of the refrigerator in future, remove the door.
- This appliance contains no user-serviceable parts. If it suffers any failure or damage, cease usage and contact Kogan Support after consulting the Troubleshooting section of this manual.
Operation
Notes on using the product
Install on a flat surface with sufficient ventilation, especially around the back of the refrigerator: allow a gap of at least 200mm around the back and 100mm around the sides.
Avoid humidity: humidity inside the appliance can form frost and impair cooling.
If frost forms, defrost refrigerator. Never clean with running water or dishwater.
Avoid placing your refrigerator near a heat source. This helps the refrigerator to work more efficiently and keep its contents cool. Do not place hot food or drink inside refrigerator.
Battery Protection: You can use the battery protection switch to select Low, Med and High settings for battery protection. The values for when the compressor stops running (cut-out) and when the compressor restarts working (cut-in) are listed below.
Battery Protection |
12V CUT-OUT |
12V CUT-IN |
24V CUT-OUT |
24V |
LOW |
10.2V |
11.2V |
21.6V |
23.0V |
MED |
10.7V |
11.7V |
22.6V |
24.0V |
HIGH |
11.7V |
12.7V |
24.6V |
26.0V |
Battery Display
Buzzing:
1.If you press any button, the refrigerator will have a buzzer alarm sound.
2.The battery gauge to display the gear to 1, a buzzer alarm sound.
Temperature setting range: -18°C~10°C
LCD Display range: -20°C~40°C
Press the button or button to adjust the temperature the unit aims to achieve. Press the button to increase or the button to decrease the temperature.
ON/OFF power button: Hold ON/OFF button for 3 seconds to turn the unit off, hold the ON/OFF button for 3 seconds to turn unit on.
If the power source is cut off or disconnected, the unit will switch off automatically and once the power is restored it will automatically switch back on with the same settings.
Compressor Speed button: Set the speed of the compressor, MAX (3000 RPM) or MIN (2500 RPM). The LCD will indicate which speed is selected.
Light control: Press the button to turn on the left and right cabinet lights. Press again to turn off. The light will be turn off automatically in 3 minutes.
Cleaning and Care
- Always ensure the appliance is turned off before cleaning.
- Clean inside and out with a damp cloth every week of use. If dirty, use sodium bicarbonate dissolved in lukewarm water.
- Never use abrasive products, detergents or soap. After washing, rinse with clean water and dry carefully. Do not leave the refrigerator shut off, warn inside, with food inside or lid closed.
- Never clean with running water, dishwater, abrasive cleaning agents or hard objects as these can damage the refrigerator.
Troubleshooting
Issue |
Steps to Resolve |
Does not turn on |
Check power supply condition and connection |
Check if fuse has burned out |
|
Ensure appliance has been turned on |
|
Food is frozen |
Raise set temperature |
Does not cool sufficiently |
Ensure refrigerator is not overfilled |
Ensure door is shut |
|
Check door seal |
|
Ensure food placed in refrigerator it not too hot |
|
Ensure proper ventilation around refrigerator |
|
Check for heat source around |
|
Lower set temperature |
|
Sound of liquid is audible |
Caused by flow of refrigerant, no problem |
Refrigerator makes noise |
Ensure level surface and clearance around |
Check for internal obstructions |
Error Codes
If the refrigerator turns off, it will remain off for 2 minutes. Turn on after the problem is resolved.
Code |
Error instruction |
E5 |
Compressor controller overheat protection (cooling system overloaded or ambient temperature too high) |
E4 |
Compressor motor turning speed error |
E3 |
Compressor motor start error (motor block or cooling system pressure too high, >5bar) |
E2 |
Fan overcurrent protection (control module fan over 1Amp) |
E1 |
Battery protection (pressure exceeded cutoff) |